SAA BILLET AR-308 (DPMS Pattern) 80% Lower Receiver - Anodized - 2 Pack
7075 T6 aluminum billet AR-308 lower receiver finished to 80%. No FFL or dealer transfer required.
The magwell is finished and is a closed, winter trigger guard design. Receiver needs the trigger group channel finished. Also additional milling is required in the rear takedown pin pocket.
Another unique design to this billet 80% receiver is the hole for the takedown pin detent and spring is installed from the bottom, similar to the selector detent and spring.
Finally it has a position for a tensioning screw as well (not included).
- Precision Machined
- 7075 T6 Aluminum
- Matte black hard coat anodized Type 3 Class 2 Finish
- Full DPMS Pattern Reiver Compatibility
- Quality Made in the USA
NOTE: Know your state's laws on these. No shipments to NJ, per your states' laws. We will not be held responsible for this product's misuse or if you do not conform to your state's laws on this part as you are responsible for following your state/location's laws on such parts. Warranted against manufacturer's defect.
3 Reviews Hide Reviews Show Reviews
Cheap price and great quality
I put these in my DPMS 80% jig and they were a few hundreds larger than the jig could tighten up on so I had to modify the jig. Maybe because they are billets they are larger than if they were forged.
These are impressive lowers.
This is a really good quality lower for the price. The only problem I found is that the hole for the upper torsion screw is not drilled or tapped.